Desa CGEFP33NR - Manual (Page 22)

108117-01J
For more information, visit www.desatech.com For more information, visit www.desatech.com
22
INSTALLATION
Installing Logs (CGEFP33PR/CGEFP33NR) (Cont.)
Installing Logs (EFP33PR/EFP33NR)
INSTALLATION
Continued
Figure 43 - Installing Front
Log (#3) Figure 44 - Installing
Crossover Log (#4)
Front Log (#3)
Post
Recess
Post
4. Locate the notches in the bottom of the crossover log (#4). Place
the crossover log on top of the middle log and front log. Make
sure the notches of the crossover log lines up with rectangular
knobs on top of the middle and front logs (see Figure 44).
Crossover
Log (#4)
Rectangular
Knobs
INSTALLING LOGS (EFP33PR/EFP33NR)
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place the base of the middle log (#1) in the U-shaped slots of
the grate base. The cutout on the right of the middle log should
fit over the burner (see Figure 45). Make sure the front of the
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: Do not remove the warning and in-
struction labels attached to the heater base assem-
bly. These markings contain important warranty
information.
CAUTION: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to HIGH, check to see
if flames contact any log. If so, reposition logs ac-
cording to the log installation instructions in this
manual. Flames contacting logs will create soot.
Figure 48 - Installing
Crossover Log (#4)
Figure - Installing Back
Log (#2)
Figure 47 - Installing Front
Log (#3)
Figure 45 - Installing Middle
Log (#1)
Middle
Log (#1)
"U"-
shaped
Cutout
in Base
Burner
Back Log (#2)
Peg
Peg
Grate
Fingers
Notches
Front
Log (#3)
Crossover
Log (#4)
Peg
Recess
middle log is resting on the tabs of the grate base and the cut-
out area is centered over the burner “U” bend.
2. Locate pegs on the bottom of back log (#2). Slide these pegs into
the holes in the grate base behind the burner (see Figure 46).
3. Locate the notches in the bottom of the front log (#3). Place
the front log on the grate fingers. Make sure the notches of the
front log line up with the grate fingers (see Figure 47).
4. Place crossover log (#4) onto the peg (right) on back log (#2)
and into the recess of the middle log (#1) (see Figure 48).