CHIAYO SDR-5932 - Manual (Page 3)

圖二
2
Making changes to various settings on SDR-5932 receiver
1. Changing CHANNEL / FREQUENCY
This can only be operated by the UP and DOWN buttons. After a desired channel is
selected, it will be automatically saved and stored into the memory.
2. Adjusting VOLUME level
Volume level can be adjusted by rotating the designated volume knob. Clockwise to
increase the volume and counterclockwise to decrease the volume.
3. Adjusting SQUELCH level
The squelch control is on the back of the receiver. When strong interference happens to
the operation, you can use a small screw driver to increase the squelch level by turning
the switcher clockwise. If the interference is too strong even the level is already set to
maximum, the currently in-use channel is not applicable in this location and a change to
channel is recommended.
Receiver installation
For best operation, the receiver should be at least 1m
above the ground and 1m away from a wall or metal
surface to minimize reflections. The transmitter
should also be at least 1m away from a wall or metal
surface to minimize reflections. The transmitter should
also be at least 1m away from the receiver.
Keep antennas away from noise source such as
motors, automobiles, neon light as well as large metal
objects.
There are two audio connecters on the rear of this unit, Mic-level balanced and Line-level
unbalanced. Use shielded audio cable for the connection between this unit and the
mixer/amp or audio source. If the mixer/amp has a 1/4" phone jack, connect a cable from
the 1/4" unbalanced audio output from the receiver to the mixer/amp. If the mixer has an
XLR input, connect a cable from the balanced XLR audio output from the receiver to the
mixer input.