CHIAYO SDR-8200 - Manual (Page 3)

Operating the Guitar System
1.Refer to Fig.6 below, connect the AC power adaptor to the DC IN connector on the back
of the receiver. Plug the adaptor into an AC wall socket. Push to switch on the receiver.
The LCD on the receiver will glow.
2.Raise the antennas and point away from each other at a 45 angle from the vertical to
achieve optimum reception.
3.Connect the receiver's Unbalanced 1/4" PHONE JACK AUDIO OUT connector to the
amplifier input, using a standard guitar cable.
4.Connect a Guitar cable to your Guitar and Adjust the volume control of your Guitar to
desired level in order to match wireless output to that of a wired system.
5.Plug the other end of the Guitar cable to the beltpack transmitter's input connector. Press
the power on / off switch to switch on the transmitter. The transmitter's red LED will flash
and the receiver's red DIVERSITY A/B lights will glow.
6.Slide the transmitter's AUDIO ON / OFF switch to ON position.
7.Play your Guitar. Proper operation is indicated by :
Steady glow of the receiver's DIVERSITY A / B lights and RF indicator.
flickering of the receiver's AF indicator lights when the audio goes into the mike.
8. During the pause of the presentation, slide the Audio ON / OFF switch to OFF
position.
9.When the performance is over, turn off the amplifier and turn off the transmitter power.
O
3 1 2 1.GND
2.
3. + -
Fig.6
1.GND
2.
3. + - 3 1 2
16
10
1.Power sw itch
2.Dive rsi ty AB indica tor
3.RF indica tor
4.AF indica tor
5.LCD
6.UP button
7.DOWN button
8.MENU
9.SET
10.Mic-ba ttery weak indica tor
11.Antenna B (TNC so ck et)
12.Unbalance d AF out
13.Balance d AF out
14.Squelch co ntrol
15.DC in
16.Antenna A(TNC so ck et)
SDR-7200 Mo dels
Frequency Ba nd
No .of Ch annel
No .of Re ceiver
Di splay
Ra ck size
Po we r supply
Ra ck mo unt oiece
Ha ndheld Transmi tter
Bo dypack Transmi tter
Ba ttery used
Re ceiving mo de
SDR-8200
UHF
100
1 2
TRUE DIVERSITY
WHITE IN BLUE LCD
1/2 19" RACK 19" RACK
12V / 800 mA AC adapto r
SQ-6100 SQ-7100
SM-7100
AA * 2 pcs ( Alkaline recommended )
MP-50 ( optional )
－
12V / 800 mA AC adaptor or switching power
Parts and functions of SDR-7200 receiver
Front
Rear
13 2