CITIZEN H461 - Manual (Page 30)

61
B. Setting the Reference Position after All-Reset
(1) Align the second hand and minute hand at 00 minutes 00 seconds.
· Turning the crown (by one click) causes the second hand to advance by one second,
and the minute hand to advance in coordination with the second hand. Turn the
crown to the right or left to set the second hand and minute hand at 00 minutes 00
seconds.
· Turning the crown continuously (by two clicks or more) causes the second hand
and minute hand to move continuously. Turn the crown to the left or right to
interrupt continuous movement of the second hand and minute hand.
(2) Push in the crown from the second position to the first position, set the date between
31 and 1 and set the hour hand to 12:00.
· Turning the crown continuously (by two clicks or more) causes the hour hand to
move continuously. When the hour hand makes two revolutions, the date changes
by one day. Continuously advance the hour hand until the date is displayed
between 31 and 1. Turn the crown to the left or right to interrupt continuous
movement of the hour hand.
· After displaying the date between 31 and 1, slowly turn the crown until the hour
hand indicates 12:00.
60
11. All-Reset
The watch display may become abnormal due to
the effects of static electricity or a strong shock. If
this happens, perform the all-reset procedure and
then set the reference position.
A. All-Reset Procedure
(1) Pull out the crown to the second position.
· The second hand rapidly moves to the reference
position stored in memory and stops.
(2) Press buttons (A) and (B) simultaneously.
This completes the all-reset procedure. Always make sure to set the reference
position according to “B. Setting the Reference Position after All-Reset” after
performing the all-reset procedure.
Note:
· Do not push in the crown to the normal position until the reference position has been set
after performing the all-reset procedure.
Button (B)
Button (A)