Cloud Electronics CX163 - Manual (Page 15)

9 Bose® Active Equalisation Modules
Each output channel has the facility to connect a plug-in Bose® equaliser module.
See the table below for details of the connector for each output.
Installation:
1. Switch off the mains supply and remove the CX163's power lead.
2. Remove the unit's top panel
3. Fit the Bose® EQ module to the connector. The EQ card should be perpendicular to the main
board.
4. Apply moderate pressure to the Bose® EQ module until it locates with a click.
5. Replace the top panel.
Current Consumption:
The CX163 can provide 90mA of power to internal equalisation modules. If this limit is exceeded, the
unit will eventually overheat and then shutdown. Below is a table detailing the types of available
equalisation module and their relative current consumption.
CX163 Stereo Zone Mixer Installation and Setup Guide
CLOUD ELECTRONICS LIMITED
9 V2 100904
MODEL OF EQUALISATION MODULE CURRENT REQUIRED
M8, M32, MA12, 402, 502A, 802, MB4, MB24, 502B, 502BEX 12mA
LT3302, LT4402, LT9402, LT9702 17mA
M16 24mA
Current Consumption of Active Equalisation Modules by Model