Code CR4100 Quick Start - Manual (Page 11)

C006244_01_CR4100_QuickStart_Guide 7
6. Click on the Data Matrix icon.
7. A pop-up will appear with the following titles (Figure 18). Click on any of these items to change the
configuration settings.
• Option
• Symbologies
• Prefixes/Suffixes
• Button Setting
• File Install
• About
• Result Window
• Close
3.1 - Option Settings
Click on Option in the list to change the Module and Sound Settings (Figure 18)
Module Settings (Figure 19):
AIM ID – Click to Enable/Disable AIM IDs
Ext Illumination – Click to Enable/Disable External Illumination. This option should be Enabled.
Run at startup – Click to Enable/Disable Run at startup.
Enter after Read – Click to Enable/Disable an enter key to be added after a good read.
Default Symbologies – Click on this box to reset all symbologies to the Default settings.
Read Timeout – Select a value for the amount of time (seconds) to try for a good read.
Output – Click on this option to change the output settings to keyboard.
Sound Settings (Figure 19):
Default – Beep tone on a good read.
No Sound – There is no tone on a good read.
Wav – Select a wav file to be played on a good read.
Vibrate – Click to Enable/Disable a vibration on good read. This option functions independent of the 3 options above.
3.2 - Symbologies
1D Tab (Figure 20)
Code 39 – Click to Enable/Disable Code 39
Code 128 – Click to Enable/Disable Code 128
Interleave 2 of 5 – Click to Enable/Disable Interleaved 2 of 5
Codabar – Click to Enable/Disable Codabar
Code 93 – Click to Enable/Disable Code 93
EAN/UPC – Click to Enable/Disable EAN/UPC
EAN/UPC Extension – Click to Enable/Disable EAN/UPC Extension
MSI – Click to Enable/Disable MSI Plessey
Code 11 – Click to Enable/Disable Code 11
Matrix 2 of 5 – Click to Enable/Disable Matrix 2 of 5
NEC 2 of 5 – Click to Enable/Disable NEC 2 of 5
Telepen – Click to Enable/Disable Telepen
GS1 Databar – Click to Enable/Disable all types of GS1 Databar (formerly known as RSS)
Figure 18
Figure 19
Figure 20