Code CR4100 Quick Start - Manual (Page 9)

C006244_01_CR4100_QuickStart_Guide
2.10 - Battery Status Indicator
Battery is empty.
Battery is charging.
Battery has a full charge.
1. At the top of the CR4100, peel back the rubber grommet to expose the SD Slot
(Figure 12).
2. Insert the SD Card in the proper orientation.
3. Push the rubber grommet back into the slot.
4. Make certain that the rubber grommet is seated properly, to maintain a seal
and ensure the CR4100’s IP65 rating.
5
2.9 - Connecting the Communication Cable to the Charging Cup
2.8 - Using the Charging Cup
1. Slide the Charging Cup (Figure 10) onto the bottom of the CR4100.
2. Connect the Power Supply into the back on the Charging Cup. This will charge the CR4100.
3. Please refer to the LED Indicator Section (Sections 2.3 and 2.4) of this QuickStart Guide for
charging LED status descriptions.
Figure 10
Figure 12
2.11 - Inserting an SD Card
1. To use the CR4100/Charging Cup as a USB Client, slide the white switch located on the back
of the Charging Cup to the (C) position (See Figure 11).
2. Connect the communication cable (USB cable supplied) to the Cradle and the
host device (PC).
Figure 11
The battery status indicator is located in the top right corner of the CR4100 window screen.