Cleaning and maintenance – Desa VESBMRA User Manual

Page 6

Advertising
background image

www.desatech.com

119668-01A

6

CLEANING AND

MAINTENANCE

WARNING: Always discon-

nect power and allow the heater

to cool before performing any

cleaning, maintenance or reloca-

tion of this heater. Turn controls

to OFF and remove plug from

outlet or turn off circuit breaker

to heater.

Turn off heater and circuit breaker to heater before

performing any cleaning and/or maintenance. Al-

low heater to cool completely.

bUlb RePlACeMeNT

WARNING: The halogen light

bulbs in your unit can become

extremely hot. Allow at least 10

minutes between turning off the

heater and removing the light

bulbs to avoid accidental burns.

There are a total of 5 ( halogen light bulbs (type

GX6.35 rated 120 volts, 35 watts) in your unit.

• 1 bulb provides illumination for the ember bed

beneath the log set

• 2 bulbs provide illumination for the flame

generation assembly

• 2 bulbs for replacement

Most halogen light bulbs are rated to last approxi-

mately 1800 hours. Like all light bulbs, halogen

bulbs require periodic replacement. When the

bulbs in your unit have burned out you will notice

one or more of the following:

• Flame is dim or dark in certain areas

• Log set ember bed appears dim or dark in

certain areas

WARNING: Do not install

replacement bulbs that exceed

specified maximum watts.

Your unit must be opened from the back in order

to replace the flame generation bulbs. To replace

the bulb under the ember bed you will open the

unit in front.

Replacing log Set ember bed bulb

1. Turn knob and open door of stove.

2. Push in and up on lower front panel. The panel

slides into notches on front sides of stove as

shown in Figure 5.

3. Remove two screws securing grate. Remove

grate.

4. Hold log up away from bulb and carefully

remove spring clip over bulb using needle

nose pliers. Remove bulb.

5. With log being held up away from socket,

insert new bulb and carefully replace spring

clip using needle nose pliers.

Replacing Flame Generation bulbs

1. Unscrew 4 screws from louvered back

panel (see Figure 6). Remove louvered back

panel.

Figure 5 - Ember Bed Bulb Location

Grate

Lower Front
Panel

Bulb in Socket
with Spring Clip

Log

Louvered
Back
Panel

Lower
Back
Panel

Figure 6 - Back of Stove

Back
Control
Panel

Advertising
This manual is related to the following products: