Desa VESBMRA - Manual (Page 7)

www.desatech.com 119668-01A 
Flame
Cylinder Drum
Figure 8 - Flame Generation Cylinder
Drum
CLEANING AND
MAINTENANCE
Continued
Flame Cylinder
Drum
Figure 7 - Flame Cylinder Drum Location
2. Locate flame generation cylindrical drum (see
Figure 7). It is constructed of two removable
halves; either of which can be removed from
the unit.
3. Squeeze half of drum cylinder until it's top
edge clears the top drum track (see Figure 8).
Remove bottom edge of cylinder drum from
bottom drum track. This will give you access
to the light bulbs. Note: Do not exert exces-
sive pressure on drum cylinder as this may
cause damage.
4. Remove spring clip. Hold socket and pull out
old bulb.
5. Hold socket and push in new bulb (DO NOT
exceed wattage). Replace spring clip.
6. Repeat steps 3 and 4 for second bulb.
7. Insert bottom edge of removed cylinder half into
bottom drum track. Gently squeeze drum cylin-
der until it's top edge fits into top drum rack.
8. Replace louvered back panel.
Replacing Glass
1. Remove top of stove by sliding top toward
the back (see Figure 9). Top fits into slots and
should slide off easily.
2. Remove four screws securing back control panel
(see Figure 10). DO NOT STRESS WIRES.
3. Remove four screws securing heater/blower
assembly to stove assembly (see Figure 10).
Assembly must be held securely while remov-
ing screws.
Figure 9 - Removing Top of Stove
Figure 10 - Removing Glass Panel
Top of Stove
Heater/Blower
Assembly
Back Control
Panel
Glass
Panel