Comtech EF Data CiM-25/600 User Manual
Page 60
CiM-25/600 IP Enabled M&C
Rev. 3
SNMP Interface
CD/CIM25600.IOM
40
3.5.1.14 C
HANGE
HTTP P
ORT
Using the !PT command, the Administrator can set the HTTP Port. The command
protocol is as follows:
Format:
!PT <value>
Response:
Command Successful
Where <value> can be any number in the range of 0 to 65535
Query Format:
!PT ?
Response:
!PT <value>
Notes:
1. The default port is set to 80.
2. Changes made via this command do not become active until the user has sent
a !EE command to commit the changes to EEPROM of the CiM-25.
3.5.1.15 C
HANGE
SNMP T
RAP
A
DDRESS
Using the !TP command, the Administrator can set the SNMP Trap Addresses. The
command protocol is as follows:
Format:
!TP <ip_address1> <ip_address2>
Response:
Command Successful
Note: An IP Address of 0.0.0.0 disables the trap
Query Format:
!TP ?
Response:
!TP <ip_address1> <ip_address2>
Note: Changes made via this command do not become active until the user has sent a !EE
command to commit the changes to EEPROM of the CiM-25.
3.5.1.16 C
HANGE
SNMP T
RAP
C
OMMUNITY
Using the !TC command, the Administrator can set the SNMP Trap Community. The
command protocol is as follows:
Format:
!TC <string>
Response:
Command Successful
where <string> can be 0 - 20 characters
Query Format:
!TC ?
Response:
!TC <string>
Note: Changes made via this command do not become active until the user has sent a !EE
command to commit the changes to EEPROM of the CiM-25.