B.3.1 rf cable (type ‘n’) – Comtech EF Data LPOD User Manual
Page 203
LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
MN-LPOD
Appendix B
Revision 10
B-11
B.3.1
RF Cable (Type ‘N’)
Use this Type ‘N’ cable for the Rx or Tx connections in LPOD Standalone or 1:1 Redundancy applications:
•
For LPOD PS-1 C-Band and X-Band applications – For Standalone use, the cable connects the unit’s ‘J2 | RF OUT’ port directly to the your Rx
signal destination. For 1:1 Redundancy applications, use the cable to connect each LPOD’s ‘J2 | RF OUT’ port to the Tx Waveguide switch.
•
For all LPOD applications – For Standalone use, the cable connects directly from these LPOD interfaces to your Rx signal destination or Tx
signal source. For 1:1 Redundancy applications, use the cable to connect the ‘J1 | LBAND IN / Tx IN’ or ‘J10 | MODEM Rx’ ports in 1:1
Redundancy applications to the system’s respective signal splitters.
Figure B-7. 1/4" Heliax Coaxial Cable (CEFD P/N CA/3722-X)