ConnectGear GP-10P - Manual (Page 60)

User's Manual
:ht=1:\
:ha=print_server_ethernet_address:\
:ip=print_server_ip_address:
Lines should be indented with tabs.
Where hostname is the device name of a PrintSir, the ht=1 tag
specifies the hardware type is Ethernet, the ha= tag specifies the
Ethernet address of a PrintSir, which is the Node ID located on the
PrintSir. The ha tag must be preceded by the ht tag. The ip= tag
should correspond to the IP address you want to assign to the PrintSir.
For example, a PrintSir with the following configuration:
Node ID: 0000B4010101 (this implies Ethernet
address is 0000B4010101),
IP address: 203.66.191.12
The entry for this PrintSir in the /etc/bootptab file should be:
PS010101:\
:ht=1:\
:ha=0000B4010101:\
:ip=203.66.191.12:
6.3.4 RARP
The procedure below enables the RARP daemon running on your
system to respond to a RARP request from the PrintSir and to assign
the IP address to the PrintSir.
1. Log in the host of RARP server as the superuser (root).
2. Assign a name corresponding to the PrintSir’s IP address. You