CREATOR CR-PGMIII - Manual (Page 13)

CREATOR CHINA 2011-03 WWW.CREATOR1997.COM
6 PGMⅢ Programmable Ethernet Control System
Chapter Three,Receiver
3.1 CR-WF10 Wireless Access
Point
The CR-WF10 is a wireless router with
delicate, elegant design.
The wireless AP provides the communication
between the CR-PGMIII and CREATOR Wifi
wireless touch panels to ensure the easy, flexible
and highly effective control experience.
Features
◆
Resistible to 12KV static electric shock
◆ WEP 64bit/128bit digital encryption technology
has been applied to ensure the stableness and
confidentiality of the transmission to avoid tapping
and interference.
◆ One RJ45 interface has been provided for the
connection to the CR-PGMIII or Network Switch.
High-quality CAT5 cable is recommended.
◆
Configuration Mode: AP Mode, Point to Point
Bridge Mode and Point to Multiple Point Bridge
Mode.
◆ The signal coverage can reach up to a circle
area of 15 meters radius without strong block.
The general coverage is a circle area of 10meters
radius
◆ IEEE802.11g,IEEE802.11b standards
supported;
◆ Dual-antenna to ensure the stableness of
transmission
Interfaces:
Front Panel：
Rear Panel：
① POWER
Power indicator: it will be ON if the device is
powered on, otherwise it will be off.
② PoE
Ethernet power supply indicator: when the
Ethernet powers the device, it will be on.
③ WIRELESS
Wireless network signal indicator: when there is
wireless signal transmitting, the indicator will on,
meaning it is sending or receiving data.
④ ETHERNET
Ethernet signal indicator: when there is Ethernet
signal transmitting, the indicator will on, meaning
it is sending or receiving data.
⑤ Antenna
A pair of rotatable antenna has been provided for