Cybex 18020 Bravo Pull User Manual
Page 15
15
Cybex 18020 Bravo Pull Owner’s Manual
Securely anchor machine to the floor
To maximize stability, equipment must be secured to a solid level surface.
•
Cybex is not responsible for the actual anchoring of equipment. Consult with a
professional contractor.
•
Use fasteners having a minimum of 500 lbs. tensile capacity (3/8’’ grade 2 bolts or better).
•
If legs/frame does not contact surface, DO NOT pull down with anchors. Shim any leg or
frame not in contact with surface using flat washers.
Install individual weight plates one at at time
1. Position each weight plate so wide edges of bushings face upward and narrow edges
of bushings face downward.
CORRECT
Wide bushing
edge faces upward
The narrow bushing edge
must face downward.
WRONG
2. Install lifting post.
3. Snap guide rods in to position
Cable routing
1. Reinstall removed pulleys.
2. Position pulley mount parallel to the top weight.
3. Pull down on pulley mount until cable is tight.
4. Verify cable is still routed through all pulleys.
5. Attach pulley mount to lifting post using a hammer and spiral pin.
Spiral
pin