Cybex 12231 VR3 Dip Chin User Manual
Page 13
Cybex Owner’s Manual
13
3. Slide belt through slot in belt clamp.
4. Verify belt and insert are installed properly. Do not install the insert backwards.
Correct belt routing
Wrong belt routing
Stem
Insert
Stem
Belt
Insert
Belt
5. Pull belt through clamp until input arm measures 31” from floor. Measure from floor to lower
edge of caution decal (located on foot bar).
Foot Bar
31”
Caution Decal
6. Pull belt tight and secure belt to clamp with the two set screws.
7. Torque set screws 300-350 lb-in.
8. Place weight stack pin in each plate to verify proper installation.
9. Simulate normal operation by lifting top weight up and down with out selecting any
resistance.
10. Verify that the belt is moving smoothly and is routed straight from the top pulley bracket to the
the weight belt clamp.
11. Turn the Increment Weight Adjusting Knob to select 0 lbs or 0 kg.
Install back shroud
1. Place shroud into position.
2. Starting at the bottom replace the two BHSCS to secure bottom support bracket to the
shroud.
3. Install but do not tighten remaining BHSCS securing shroud.
4. Tighten all BHSCS.