Daktronics SW-2101 Aquatics/Track LED Scoreboard - Manual (Page 18)

12 Electrical Installation
3.7 Setting the Driver Address
Each driver in a scoreboard module must be set
to receive the correct signal input, or address, for
the control system being used.
Addresses are set through the S2 (L) and S3 (H)
rotary switches on the driver (Figure 7) using a
small flathead screwdriver.
Refer to the tables on the following pages to
determine the correct driver address settings
based on the control system in use.
Figure 7: Driver Address Dials
Omega OSM6 or Scan’O’Vision
Function Address
Line 1 (or 1 and 2) 1 (H = 0, L = 1)
Line 2 (or 2 and 3) 2 (H = 0, L = 2)
Line 3 (or 3 and 4) 3 (H = 0, L = 3)
Line 4 (or 4 and 5) 4 (H = 0, L = 4)
Line 5 (or 5 and 6) 5 (H = 0, L = 5)
Line 6 (or 6 and 7) 6 (H = 0, L = 6)
Line 7 (or 7 and 8) 7 (H = 0, L = 7)
Line 8 (or 8 and 9) 8 (H = 0, L = 8)
Line 9 (or 9 and 10) 9 (H = 0, L = 9)
Line 10 10 (H = 0, L = A)
Line 4, MS w/ Horn 15 (H = 0, L = F)
Line 6, MS w/ Horn 16 (H = 1, L = 0)
Line 8, MS w/ Horn 17 (H = 1, L = 1)
Daktronics OmniSport 2000
Function Address
1-Line Timing Display 40 (H = 2, L = 8)
Line 1 (or 1 and 2) 41 (H = 2, L = 9)
Line 2 (or 2 and 3) 42 (H = 2, L = A)
Line 3 (or 3 and 4) 43 (H = 2, L = B)
Line 4 (or 4 and 5) 44 (H = 2, L = C)
Line 5 (or 5 and 6) 45 (H = 2, L = D)
Line 6 (or 6 and 7) 46 (H = 2, L = E)
Line 7 (or 7 and 8) 47 (H = 2, L = F)
Line 8 (or 8 and 9) 48 (H = 3, L = 0)
Line 9 (or 9 and 10) 49 (H = 3, L = 1)
Line 10 50 (H = 3, L = 2)
Home, Guest 1,
Guest 2, Guest 3
31 (H = 1, L = F)
Event/Heat, Lengths,
Record Time
32 (H = 2, L = 0)