6 horn, 7 replacement parts, Horn – Daktronics MS-2013 Portable LED Scoreboard User Manual

Page 29: Replacement parts, On 6.7

Advertising
background image

Scoreboard Troubleshooting

23

Important Notes:

During service, do not allow the battery terminals to touch any metal surface.
When reinstalling, make sure the terminal wires are connected correctly.
Improper connection may result in injury or damage to scoreboard components.

The batteries in these products contain lead. Do not dispose of the batteries in a
municipal waste system at the end of their useful life. Doing so may be a violation of
local, state, or federal environmental regulations. Please return the batteries to a
battery recycling center or battery retailer.

6.6 Horn

Reference Drawing:

Electrical Specifications, MS-2013 ........................................................................ A-159887

A 12 V buzzer horn is mounted in the upper-left
corner of the front face panel (as viewed from the
front). Drawing A-159887 in Appendix A shows
the horn location from the front as well as when
accessing internal components from the rear.

To replace a horn, simply disconnect the cable
running to it, and then remove the single nut and
washer holding the horn to the mounting bracket
(Figure 12).

Note: The horn volume is set at maximum during manufacturing and is not adjustable.

6.7 Replacement Parts

Refer to the following table for standard and optional replacement parts.

Description

Daktronics Part No.

12 VDC Horn Assembly

0A-1072-0023

Driver, 16-col outdoor LED

0A-1782-0100

Battery Monitor (Circuit Board)

0P-1192-0097

Digit, 10" red, 7-segment

0P-1192-0251

Battery; 12V, 28 A/H sealed lead-acid (Panasonic Model LC-X1228P)

BT-1023

Battery Charger; dual 12 or 24V, 3 A (Guest ChargePro Model 2607)

BT-1022

Fuse, AGC-10, 10A, 250 V glass tube

F-1006

Fuse, MDL-7, 7.5 A, 250 V glass tube

F-1031

Washer, ½ flat

HC-1095

Wheel Bolt, ½ -

13 x 3 ½”

HC-1363

Wheel, 10x1.75, semi-pneumatic, 1/2" axle

RA-1007

Transformer, sec. 24 V @4A, pri. 115/230V, 50/60 Hz

T-1043

Power cord, 360º rotating, 8'

W-1181

Fuse holder

X-1287

Figure 12: Horn Mounting Detail, Side View

Advertising