D-Link DFL-600 - Manual (Page 91)

gs
ing a
n the DFL-600.
VPN-L2TP Settin
The Layer 2 Tunneling Protocol (L2TP) is another method of establish
secure tunnel between your DFL-600 and a remote gateway. The L2TP
Status page allows you to enable or disable L2TP o
L2TP Pass Through Click Enable to allow L2TP packets to pass
n through the router to the destination computer o
your LAN. When IPSec Pass-through is
enabled, the DFL-600 will allow L2TP packets
to reach their destination computer on your
LAN.
L2TP Status L2TP can be Enabled or Disabled by clicking
the appropriate click-box and the clicking the
Apply.
Starting IP Address This allows you to specify a range of IP
addresses for servers on your network that can
, enter this address in both the Starting
fields.
use the L2TP protocol. If you have only one IP
address
IP Address and Ending IP Address
Ending IP Address This allows you to specify a range of IP
addresses for servers on your network that can
use the L2TP protocol. If you have only one IP
address, enter this address in both the
IP Address and Ending IP Address
Starting
fields.