Daktronics GPR-12EV-RGB - Manual (Page 25)

Start-up Procedure 19
Section 5: Start-up Procedure
Before starting the display, review the following list. Figure 3 shows the basic display components
referred to in each step.
5.1 Start-up Checklist
• Confirm that power is correctly connected to the display.
• Allow for sufficient power as listed in the display Shop Drawing and Power Specs.
• Assure a main disconnect switch is used to control power.
• Inspect all circuit breakers (internal and external) for sufficient marking and size.
• Confirm that adequate grounding is installed. Each display face must have a separate
earth-ground conductor with a resistance of 10 Ohms or less.
• Assure the external communication equipment (signal enclosure, client radio, etc.) is
properly installed.
• Inspect signal connections at the control computer.
• Inspect signal connections at the display.
Inspect signal connections between displays when necessary.
• Confirm that the control computer is correctly configured.
Follow the step-by-step directions in the Venus ® 1500 Help File’s Configuration
section for correct setup.
• Inspect peripheral equipment (temperature sensor, etc.) for proper installation.