Datatek HP-UX 10.20 (32 bit kernel - Manual (Page 9)

I P - C o m m K i t I n s t a l l a t i o n a n d A d m i n i s t r a t i o n G u i d e
f o r H P - U X – I s s u e 2 – R e l e a s e 1 . 0 . 2 2
10/13/11 Datatek Applications Inc. 9
<TRK-UNIV> trk type=IPDSU
<TRK-UNIV> trk modtype=CPM
<TRK-UNIV> lo ipaddr=utm_ip_address submask=utm_subnet_mask
<TRK-UNIV> ga ipaddr=gateway_ip_address
<TRK-UNIV> trk dest=host_ip_address
Here the IP addresses and subnet mask are shown in bold Italics. You would replace these
names with numbers when you enter the commands.
Enter the following command to check the configuration:
<TRK-UNIV> vfy mod
The output should be similar to the report below.
Current Configuration:
DK Board Type ==> TN1009 (CPM-HS) w/Serial# 136.
Service State ==> Out of Service.
Operating Mode ==> Simplex.
Trunk Type ==> IP-DSU Compatible Trunk on 10BaseT Network Port.