Devolo dLAN 500 AV Wireless+ - Manual (Page 16)

Quick start 15
devolo dLAN 500 AV Wireless+
Begin carrying out the configuration of
your network in order to secure your
Wi-Fi network in a customised manner.
For more information, refer to Chapter
6 Network configuration.
Encrypting a new dLAN network with one or more
dLAN 500 AV Wireless+s and a dLAN 500 AVplus
(starter kit and single kit)
Note the Wi-Fi key of the
dLAN 500 AV Wireless+ before the
networking procedure. You will find
the unique adapter key on the label on
the back of the housing.
ቢ Connect the dLAN 500 AVplus to your Internet
access device's network jack.
ባ Plug the dLAN 500 AV Wireless+ into a wall
socket. As soon as the dLAN indicator light lights
green (after approx. 45 seconds), the adapter is
ready to operate.
If you only want to use the Wi-Fi func-
tion on the dLAN 500 AV Wireless+,
plug the adapter into a power outlet,
without any cables whatsoever. You
can also connect the
dLAN 500 AV Wireless+ to the network
jack of a network device, such as a
computer, with a commercially availa-
ble network cable (see 2.3.3 Sample ap-
plications).
The power outlet should be in range of
the connected network device.
The dLAN 500 AV Wireless+ with the
cable-based network device should be
easily accessible.
To switch off the
dLAN 500 AV Wireless+ or disconnect
it from the mains supply, pull the pow-
er plug out of the power outlet.
ቤ After you have successfully connected both adapt-
ers, press first the encryption button of the
dLAN 500 AVplus (approx. 1 second) and then
the dLAN button of the
dLAN 500 AV Wireless+ (approx. 1 second)
within two minutes.