Dish Network 6.4 - Manual (Page 23)

11
D ISCRETE C ODES FOR L EARNING R EMOTES
Note: Discrete codes are only used by IR remotes (either the TV1
remote or a universal remote).
Remote control discrete On and Off IR commands are used by
installers when programming macro commands into universal remotes.
Using an On-only or Off-only command is more effective than a toggle
On/Off command when trying to ensure the satellite receiver is reliably
in one state or the other. To use discrete power commands, complete
the following:
1 Program the DISH Network remote to the desired remote address
(see Changing the Remote and Receiver Address in the next
section).
2 Hold the SAT mode button until all mode buttons light, then
release.
3 Press POWER (not TV POWER).
4 Press VOLUME UP for discrete power on, or VOLUME DOWN
for discrete power off.
5 Press any other button when done to end this procedure.