Diamondback Fitness 510Ic - Manual (Page 14)

12
FINAL INSTALLLTION & SET UP
• Moving and Posi oning the Unit. Move the 510Ic into the
desired fi nal posi on by carefully raising the rear end of the unit
un l the wheels located on the front stabilizer contact the fl oor.
Leave room around the unit for safe opera on and suffi
cient air
fl ow.
• Leveling the Unit. Level the unit by rota ng the four leveling
feet (D-1) located in the stabilizer bars. Lock the feet into
posi on by ghtening the lock nut (D-2) upward, against the
frame.
• Final Adjustments – Up/Down. Raise and lower the seat and
handlebar assemblies by loosening the adjuster knobs (G-6)
with a couple of counter-clockwise rota ons. While suppor ng
the assembly, pull the knob outward, away from the frame, to
disengage the pop-pin. Raise or lower the assembly as desired,
releasing the knob to reengage the pop pin. Tighten the knob to
lock the assembly in place.
• Final Adjustments – Fore/A . Fore-a adjustment for the seat
is made by loosening the lever (L-5). Rotate the lever to the le
to loosen. If the lever movement is inhibited by the frame or
other components, pull the lever downward to reposi on the
lever and release. Con nue to loosen. Only ¼ turn should be
required to loosen or ghten the levers. Posi on the seat slide
and secure the lever.
• Plug one end of the power adaptor (N) into a 120V power
source. Plug the opposite end into the power input jack (F-16)
found on the rear end of the plas c housing.
ASSEMBLY INSTRUCTIONS