DNF Controls DMAT-AB - Manual (Page 13)

DMAT-AB Sports Controller for Abekas Mira Page 11 of 25
14. ASSIGN SPEED TO PLAYLIST ELEMENT
A. Press [UP ARROW] or [DOWN ARROW] to highlight the desired element
in the current playlist.
B. Press the {SPEED} softkey.
C. Move the T-bar to set the desired speed.
D. Press [ENTER], [UP ARROW], or [DOWN ARROW] to assign the T-bar
speed to the current element.
OR
Press [ESC] to exit without assigning speed to element.
15. APPEND PLAYLIST
An existing playlist can be appended to the end of another playlist as an
element. Upon reaching this element in the list, the appended playlist will be
automatically loaded and seamlessly transitioned to.
A. In PL mode, using the numeric keypad, select a playlist to be appended.
B. Press [LIST] to pre-load the selected playlist. The display will show the
cued playlist number next to the current playlist number.
C. Upon completing playout of the current playlist, the pre-loaded playlist will
begin playing.
D. Press [ALT] + [LIST] to cancel the pre-loaded playlist.
NOTE: The pre-loaded list will be cancelled if the operator exits PL mode or if
another playlist is appended. Only one playlist may be pre-loaded at a given
time. Playlists may not be inserted into the middle of an existing playlist.
16. CUT / MIX TRANSITIONS
2 IN / 2 OUT and 6 IN / 2 OUT modes of operation support the capability to
perform cut or mix transitions between the two playback channels. Transition
Type and Transition Time are configured in the Setup Menu.
To perform a transition, press the [TAKE] key. The currently loaded clip on P2
will automatically be put into play with the configured transition. If in PL mode,
the list will automatically be put into play using the assigned speed for that
element if applicable.