DNF Controls ST100 Shuttle Box - Manual (Page 4)

4 ST100 Shuttle Box
2. DESCRIPTION
a. STANDARD FUNCTIONS
RECORD
PLAY
STOP
REWIND
FAST FORWARD
JOG/SHUTTLE MODE SELECT
JOG & SHUTTLE WHEEL: Active ONLY from STOP/STILL or JOG/SHUTTLE
modes.
b. TIME CODE DISPLAY
Display timecode or CTL Tape Timer per the mode selector switch on the front panel of
the VTR. The Time Mode can be selected manually by pressing the [SHIFT] + [JOG]
keys, each press will step to the next Time Mode: CTL Tape Time, Timecode, VITC.
c. REAL-TIME STATUS INDICATORS: ACTIVE ON
RECORD
PLAY
STOP/STILL
REWIND/REVERSE
FAST
FORWARD/FORWARD
JOG MODE SELECTED
3. INSTALLATION
a.
Plug one end of a 9-conductor, RS422 serial cable into the 9-pin connector on the rear of
the ST100. Plug the other end of the cable into the 9-pin REMOTE connector on the
VTR.
b.
Plug the 9-pin D-female connector on the POWER SUPPLY into the male 9-pin
connector on the rear of the ST100.
Plug the AC connector into a wall outlet, 90 VAC - 265 VAC, 50-60 Hz.
c.
Select REMOTE operation on the VTR's front panel.
d.
Set the RECORD SELECTOR SWITCHES, located on the rear panel of the ST100, to
the desired record mode per the "RECORD SELECTOR CHART."
e.
Connect the second Controller to the 9-pin female connector labeled LOOP-THRU, on
the back of the ST100, using a 9-pin cable wired as described below, “LOOPTHRU
CONNNECTOR.”
Installation is completed.
NOTE: For AMPEX 1-inch and D2 VTRs, set VTR ID to 0001.