Directed Electronics Security System and Convenience 125xv - Manual (Page 18)

14
© 2004 Directed Electronics, Inc.
Page Mode On/Off
After entering Programming Mode, press within five
seconds to toggle on and off. When the Page Mode is on, the
remote control will wake up periodically to check for messages
from the security module. It will also wake up when any button
is pushed. When Page Mode is off, the remote control “sleeps”
until a button is pushed, extending the life of the battery.
To Exit Programming Mode
To exit Programming Mode, take no action for five seconds. The
remote control will generate two beeps to indicate programming
mode has been exited.
Using Your System
The following safety warnings must be observed at all times:
■ Due to the complexity of this system, installation of this
product must only be performed by an authorized Directed
Electronics dealer.
■ When properly installed, this system can start the vehicle via
a command signal from the remote control transmitter.
Therefore, never operate the system in an enclosed area or
partially enclosed area without ventilation (such as a
garage). When parking in an enclosed or partially enclosed
Warning! Safety First