ESI Dr.DAC prime - Manual (Page 7)

ESI Dr. DAC prime
7
You will now be prompted to connect the hardware on the next dialog that is shown below on the
left. Plug in Dr. DAC prime. Do not click Next yet. During the driver installation, Windows might
again prompt you to confirm the Windows Logo testing dialog once or several times with Continue
Anway before the driver installation is finalized.
You can now finally click OK on the Information dialog and then proceed with Continue Anyway
once or several times. The installation is now finished. To confirm this, please check if the ESI icon
is displayed in the taskbar notification area as shown below.
If yes, the driver installation has been completed successfully.
3.1.3 Driver for Windows Vista and 7
Disconnect Dr. DAC prime before you install the driver if it has been connected already. Then
launch setup.exe from the Windows folder of the included Installation CD or from a download of a
recent driver from our website.
When launching the installation, Windows Vista / 7 might prompt a security message. Make sure to
allow the installation. You will then see a dialog as shown on the left picture below. Click Next.
You can define the target directory for the installation now. Confirm it with Next.