ETA Dualic II - Manual (Page 27)

27
GB
/ 48
Full dust filter signaling
If the coloured field is displayed permanently on the indicator A7 (Fig. 14) while the
floor nozzle is lifted above the cleaned surface at the maximum suction power, the dust
container must be replaced. Disregard changes on the indicator during vacuuming.
Emptying the dust container
Tip out the lid A1 of the cleaner by pressing closure A2 (pic. 15). Remove container B in
a manner described above. Place the container above a dustbin and press B2 button, the
lid B3 will tip out and dump the dirt into common house waste (pic. 17). Tip the bottom
back up in a way that it is properly secured and place the container back in the cleaner
and secure. We recommend emptying out the container outside of living area for hygiene
reasons.
Cleaning the dust container of the foam and HEPA filter
After approx. 5 emptying of the container we recommend to carry out a complete cleaning
of the system from settled dust. Remove the individual parts in the following manner:
– Separator B6: press the B2 button which will tip out the bottom B3. You can release the
separator by turning it in the direction of “open” and then pulling it out (pic. 19).
– HEPA filter B5: can be released from the container by pressing the arrest latch and
pulling the filter out of the container (pic. 18).
– Foam filter B4: pull out of the container (pic. 18).
Clean all accessories (i.e. container, separator, foam filter, HEPA filter) in lukewarm running
water with a cloth or a fine brush and let dry thoroughly (pic. 23). When all the parts have
dried, assemble them back.
Replacing the dust filter
Tip out the lid A1 of the cleaner by pressing closure A2 (pic. 15). Then follow the
instructions for the respective type of a dust filter:
Paper / synthetic filter: Tip out the arrest closure A10 and slide out the dust filter D (pic.
20 A) and dispose it with common house waste. Slide the front
part of the dust filter (direction of arrow) in the three ribs in the
suction space of the vacuum cleaner and then tip out the arrest
closure and press the front all the way to the seal. Now secure the
front part with closure A10. Press to close the lid of the cleaner.
UniBag: hold adapter H and remove it from the guide ribs of holder by pulling it. By lifting
off lock stop H1, dust filter D will be released from the holder/adapter (Fig. 20 B).
Dispose of the dust filter with common municipal waste. Slide the projections on
the front of a new dust filter into the holes in adapter H and secure the front by
slight pushing. You will hear a clicking sound. Check proper fastening of the front
by slight pulling of the dust filter. Slide the adapter with a filter to the holder in the
suction space and push it to the maximum position.