ETA Dualic II - Manual (Page 28)

GB
28 / 48
Note
– Make sure that the bearing area and sealing elements are functional.
– The „UniBag” dust filter is not intended for repeated use.
– DO NOT THROW THE ADAPTER AWAY!
– Please fasten the „UniBag” dust filter back to the adapter.
– If the adapter No. 11 is damaged or lost, you can buy the respective adapter as
a spare part in the elektro shops.
i
Replacing the micro filters
After replacing approx. 5 pcs of dust filters it is necessary to clean the micro filters or
replace them by new ones in case of visible damage. Dispose of used dust filters and
micro filters with common house waste. We recommend to replace the exhaust HEPA
micro filter at least once a year (according to amount of dirt).
Suction micro filter
Pull out the cassette E with micro filter in the suction space (pic. 22). Open the cassette,
clean the E1 micro filter in running lukewarm water and let dry thoroughly (pic. 23). After
drying, insert the micro filter back into the cassette, close it, put it back behind the two
protrusions and slide it all the way into the suction space of the vacuum cleaner.
Exhaust HEPA micro filter
Remove the cover of the vacuum cleaner by pulling by the two protrusions in the bottom
part of the exhaust cover A11 (pic. 21). Pull out the cassette A12. Tap the dust out of
the filter over a dustbin or to clean the filter through a blowing (we recommend the filter
cleaning outside of living area for hygiene reasons). If the protection micro filter is very
dirty, you can also rinse the pleated side of the HEPA filter under lukewarm slow-running
tap. Hold the filter in such a way that the pleated side points upwards and the water flows
parallel to the pleats. Hold the filter at an angle so that the water washes away the dirt
inside the pleats. Turn the filter 180° and let the water flow along the pleats in the opposite
direction. Continue this process until the filter is clean. When all the parts have dried,
assemble them back.
ATTENTION
– The maximum suction effect will be reached with a clean filter and an dust filter.
– Do not use any abrasive cleaning agents or hot water to clean the HEPA micro filter or
foam filter.
– Cleaning of the filter will not restore its original colour but it will restore its filtration
functions.
– Neglecting the replacement of the micro filters may lead to failure of the vacuum
cleaner!
– The HEPA filter and the micro-filters are not intended for cleaning in a dishwasher.
– We recommend replacing the HEPA filter twice a year. Replace the other micro-filters
if they cannot be cleaned properly or if they are damaged. You can buy a replacement
dust filter, a HEPA filter and a micro-filter in the elektro shop chain.
– The HEPA filter and the micro-filters are not intended for cleaning in a dishwasher.
!