ETA Bublimo - Manual (Page 24)

Place the appliance on an even and dry surface (e.g. kitchen table), at the minimum height
of 85 centimetres, out of reach of children (see I.SAFETYADVICE).
Prior to the first use, wash the parts that come in contact with food in warm water with
soap and rinse them thoroughly with clean water, dry with a kitchen towel or air dry. The
appliance is now ready to be used.
InstallationandRemovaloftheCO
2
Carbonator (Fig. 2, 3, 4, 5)
Place the appliance on the front or side for easier manipulation. Press the arresting button
A6 on the bottom side of the appliance and then remove the back cover A4. Remove the
protective cap (seal) from the pressure bottle C (carbonator). Insert the carbonator into
the opening and turn it around (anticlockwise) so that the valve gets screwed in the holder
A8. Apply reasonable force (lightly) to tighten the carbonator. Insert the cover behind the
top part of the appliance and fasten it with a click. Proceed in reverse order to remove the
carbonator from the appliance.
ATTENTION
– Check that the carbonator valve is not damaged.
– Check that sealing is inserted in the holder and that it is not damaged or worn out.
– Do not use any tools to install the carbonator (e.g. keys, pliers).
– Do not apply excessive force to tighten the carbonator to prevent gas leak.
!
InstallationandRemovalofthePETBottle (Fig. 7, 8, 11)
Unscrew the cap B1. For easier manipulation, push down the control A2 and tilt out the
holder with the nozzle. Slide the neck of the bottle B on the nozzleA3 until it fits in the
holder A7and then apply reasonable force to turn the bottle (clockwise) as far as it goes.
Pull the bottle lightly to check that it is properly attached. Then release the inclination
control. Proceed in reverse order to remove the bottle from the appliance.
ATTENTION
– Check that the bottle is not visibly damaged.
– Do not use any tools to install the bottle (e.g. pliers).
!
IV. USE OF THE APPLIANCE (Fig. 2 - 12)
Place the appliance on a dry and even surface. Install the CO
2
carbonator correctly (see
instructions above). Fill up the PET bottle with chilled, clean drinking water up to the
level marked with MAX.
Attention:Donotaddanysyrupconcentrate,
iceorcrushediceinthewater!Youmightcausethenozzle
obstruction!
Install the PET bottle to the appliance correctly (see instructions
above). Check that the end of the nozzle A3 is immersed in water. Press the button PUSH
A1 shortly and firmly (for max. 2 seconds) to apply carbon dioxide.
Thenslowly
releasethebutton.
The carbonation of water with CO
2
is accompanied by
a characteristic sound – “soft sizzling” (i.e. letting out excess gas and pressure
equalization). This is perfectly normal and does not constitute a reason to complain about
the appliance. Press the button once or twice for standard carbonated water. Remove the
bottle from the soda maker and screw the cap B1 on the bottle. You can either consume
the prepared drink right away or store it in the refrigerator.
24
GB
/ 45