Preparation, Xdvd8181 installation – Dual XDVD8181 User Manual
Page 4
4
Mounting sleeve opening dimensions
7-3/16” x -1/16” (183 mm x 53 mm)
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
Please read entire manual before installation.
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it
would be subject to dust, dirt or excessive vibration.
Getting Started
• Remove the four #1 phillips head screws from each corner, and slide the unit out of the mounting sleeve.
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna as shown on pages 5-6. Consult a qualified technician if you are unsure.
• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).
• Test for correct operation and slide unit into mounting sleeve, secure with #1 phillips screws as removed in step 1.
• Snap trim ring into place.
• Mount the iplug™ adapter to any smooth clean surface using the supplied double-sided tape or # x 3/8” Phillips
head screws.
XDVD8181
INSTALLATION
Preparation