FiberPlex PSQ-2909 - Manual (Page 4)

Warranty, Service and Terms and Conditions of Sale
For information about Warranty or Service information, please see our published ‘Terms and Conditions of
Sale’. This document is available on
fiberplex.com or can be obtained by requesting it from
[email protected] or calling 301.604.0100.
Disposal
Disposal of Packing Materials
The packing materials have been selected with environmental and disposal issues in mind. All packing material
can be recycled. Recycling packing saves raw materials and reduces the volume of waste. If you need to
dispose of the transport packing materials, recycling is encouraged.
Disposal of Used Equipment
Used equipment contains valuable raw materials as well as substances that must be disposed of
professionally. Please dispose of used equipment via an authorized specialist dealer or via the public waste
disposal system, ensuring any material that can be recycled has been. Please take care that your used
equipment cannot be abused. After having disconnected your used equipment from the mains supply, make
sure that the mains connector and the mains cable are made useless.
Disclaimer
The information in this document has been carefully checked and is believed to be accurate at the time of
publication. However, no liability is assumed by FiberPlex for inaccuracies, errors, or omissions, nor for loss or
damage resulting either directly or indirectly from use of the information contained herein.
Introduction
The PSQ‐2909, PSQ‐3909 and PSQ‐4909 are compact AC power supplies that attach to and provide operating
voltage for FiberPlex’s FOI series isolators.
The PSQ‐2920, PSQ‐3920 and PSQ‐4920 are compact low voltage power supplies that attach to and provide
operating voltage for FiberPlex’s FOI series isolators. They can power the FiberPlex FOI units with a 12‐48 VDC
(or 10‐32 VAC) external supply. These Low Voltage power supplies are not polarity sensitive; V+ and V‐ may be
reversed for DC inputs. They are equipped with a resettable fuse to protect both the supply and the FOI.
Getting Started
Initial Inspection
Immediately upon receipt, inspect the shipping container for damage. The container should be retained until
the shipment has been checked for completeness and the equipment has been checked mechanically and
electrically. If the shipment is incomplete, if there is mechanical damage, or if the unit fails to operate notify
FiberPlex and make the shipping materials available for the carrier's inspection.