Fire Magic 3587 Sink - Manual

REV 4 - 1301300830 L-C2-270 1
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
Fig. 1-2 Sink detail
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
OUTDOOR BUILT-IN SINK
Model #: 3587
PREPARE FOR INSTALLATION
This product is intended to be used as an outdoor
sink and must be installed by a licensed professional
plumber according to all applicable local codes.
Prepare a cut-out in the countertop as specifi ed in
Table 1-1 and shown in Fig. 1-1. There must be a
minimum of
1 /
2
" overlap of the stainless-steel hanger
plate on all sides of the opening. The countertop must
be completely level for safe and effective operation
of this appliance.
Provide for access beneath the sink before and after
installation to allow for proper maintenance. Allow for
adequate water line and drain connections.
Important: All plastic fittings must be hand
tightened only! DO NOT use wrenches
on plastic fi ttings.
ATTACH FOAM-RUBBER GASKET
1. Gently place the sink up-side-down on the
countertop or other work surface. Locate the
foam-rubber gasket and begin to peel away the
protective paper.
2. Attach the adhesive side of the foam rubber liner
around the under side of the sink lip (see Fig. 1-3).
Table 1-1 Specifi cations table
Sink shown here with faucet (not included but
available separately, design may vary)
Specifi cation Value
Counter opening width 14"
Counter opening length 14"
Min. vert. clearance below counter 17"
Counter overlap beyond cutout 1 / 2 "
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION OR USE
Sink
Fig. 1-1 Cut out dimensions detail
Anchor clips
Foam-rubber
gasket
Drain Kit
14"
14"
17"
1/2" clearance all
the way around
Fig. 1-3 Attach foam-rubber gasket
(Sink bottom)
Foam-rubber
gasket