Flowserve SLM-6000 - Manual (Page 9)

9
Cartridge in Place (Dry Side) Figure 14
6 Completing Installation
6.1 Evenly tighten the Socket Head Cap Screws of the 2-piece split clamp collar, the Hex
Head Cap Screws of the 3-piece shrink disk collar, or the Set Screws of the 1-piece
sleeve collar to the proper torque values listed below.
TORQUE VALUES
ft-lbs
(N-m)
Split Clamp Shrink Disk Set Screw Set Screw Penetrating
Clamp Clamping (Cup Point)
(Dog Point)
Fastener Alloy Steel Alloy Steel Alloy Steel Stainless Alloy
Size Steel Steel
1/4” 10-12 4-6 7-8
(14-16) (5-8) (9-11)
5/16” 24-26 20-22 10-12 13-15
(33-35) (27-30) (14-16) (18-20)
3/8” 40-45 24-27 18-20 22-25
(54-61) (33-37) (24-27) (30-34)
1/2” 90-100 50-55
(122-136) (68-75)