Flowserve Airfin Coolers - Manual (Page 4)

TO REORDER REFER TO
B/M #
F.O
.
FIS154
REV 02/03 USA
Flowserve Corporation Flow Solutions Division
Printed in U.S.A.
ISO 9000
Certified
Primary Worldwide Flow Solutions Division Locations Licensees, authorized agents, and affiliated companies located worldwide
All Flowserve Corporation, Flow Solutions Division, products must be installed in accordance with Flowserve
installation instructions. Failing to do so or attempting to change or modify Flowserve products will void Flowserve’s
limited warranty. Flowserve’s limited warranty is described fully in Flowserve’s Standard Terms and Conditions
of Sale. Flowserve makes no warranty of merchantability or fitness for a particular purpose and in no event shall
Flowserve be liable for consequential or incidental damages.
Germany Brazil Mexico
Kalamazoo, MI
Phone 269-381-2650
Fax 269-382-8726
United States
Roosendaal
Phone 31-165-581400
Fax 31-165-552622
Netherlands
Dortmund
Phone 49-231-6964-0
Fax 49-231-6964-248
Edmonton, Alberta
Phone 780-463-7958
Fax 780-450-1241
Canada
Sao Paulo
Phone 55-11-4066-8600
Fax 55-11-4066-7014 Tlaxcala
Phone 52-2-461-6791
Fax 52-2-461-6847 Phone 65-6-8465100
Fax 65-6-747-1963 Osaka
Phone 81-720-85-5571
Fax 81-720-85-5575
Singapore Japan
Villa Martelli
Phone 54-11-4709-6800
Fax 54-11-4709-7072
Argentina Australia
Marayong NSW
Phone 61-2-8822-7100
Fax 61-2-9679-7511 Scarborough, Ontario
Phone 416-292-2877
Fax 416-292-5190
2 Operation
2.1 Inspect the Airfin Cooler to insure that the cooling coil has not been
painted, sprayed with oil, or covered with dirt or dust. Insure that there are
no obstructions on the top, bottom, and sides.
2.2 Apply power momentarily to the motor on the Model 625 FC to check for
rotation. If the rotation is in the wrong direction, rewire the motor.
2.3 Open the pump suction valve and fill the system with product. Crack the
vent valve in the hot product line and vent all air from the system.
2.4 Check all fittings for leaks and make required adjustments. Do not tighten
fittings excessively.
2.5 Apply power to the motor on the Model 625 FC and start the pump, for the
625 NC model start the pump.
Maintenance
The Airfin Cooler is relatively maintenance free. To insure maximum heat transfer
efficiency, keep the cooling coils dry and free of dirt and dust. Periodically, clean
the cooling coil by blowing air or steam through the protective shroud.