Digi MIL-170TRM - Manual (Page 2)

Install Guide
Model: MIL-170TRM 2
A b o u t t h i s M a nu a l
This document covers the MIL-170TRM media converter module. The terms
“MIL-170,” MIL-170TRM,” and “converter” are used throughout this document
to describe the MIL-170TRM.
I n t ro d u c t i o n
The MIL-170TRM is one of a series of modules designed to be installed into Digi's
Media Conversion System. This half-/full-duplex device converts optical signals
to electrical and vice-versa.
The device has a signal capability of transmitting up to 15 km (subject to fiber
budget and collision domain restrictions). This module also has the Link Sentry
feature.
F e a t u r e s
• One RJ-45 (UTP) connector
• One single-mode, ST connector
• Link Sentry feature
• Diagnostic LEDs
• Management ready–supplied by the optional SNMP modules (MIL-4650 and
MIL-4655)
• Power supply equipped on the rack mount chassis
I n s t a l l a t i o n
Do the following to install the MIL-170TRM into a redundant rack mount chassis:
1. Make any configuration changes to the module (i.e., DIP switch settings).
2. Remove the screws securing the faceplate and remove it from the chassis.
3. Slide the module into the slot through the guide rails.
4. Insert the module into the card-edge connector (port bay). Make sure it is
seated firmly.
5. Secure the module with the two thumbscrews located on the faceplate of the
unit.
The unit is now ready for network connections.