Flowserve Nordstrom Hypregun-Plus 5G Pneumatic Valve Sealant Injector - Manual (Page 13)

13
Nordstrom Valves Hypregun - Plus 5G FCD NVENIM2004-00-AQ 10/14
flowserve.com
Kick Stand Assembly
1. Locate two kick stands (74), one hex nut (85), one hex nut (86),
two washers (83), one capscrew (87), one capscrew (84), one
spring (76), and one washer (82).
2. Locate the kick stand mounting hole on the front of the
base (18).
3. Align the hole in the kick stand with the hole in the yoke.
Secure the kick stand into position using capscrew (87), lock
washer (83), and nut (86). The lock washer is to be positioned
between the base and nut.
4. Tighten firmly using the adjustable wrench and socket.
Locate the kick stand mounting hole on the back of the base (18).
5. Align the hole in the kick stand with the hole in the yoke.
6. Secure the kick stand into position using capscrew (87), washer
(82), spring (76), lock washer (83), and nut (85). The washer
(82) is to be placed on the capscrew and the spring against the
washer. This assembly is to be placed through the kick stand and
base holes. Install the lock washer and hex nut. The nut should be
threaded onto the capscrew until the threads appear through the
nut. If the nut is tightened too much, the kick stand spring will be
too compressed to allow for free movement of the kick stand.
7. Stand the Hypregun-Plus 5G upright.
Preparing the Hypregun-Plus 5G for Use
1. Using an adjustable wrench, install the hose assembly by
attaching the L-type swivel to the pump body (33).
2. Raise the follower (34) by connecting the air supply hose to the
nipple (57) located on the base (18) of the gun.
3. Remove the can shield (72) and install a new five-gallon
(18.9 litre) can of Nordstrom valve sealant. To prevent the can
from splitting at the seam, the opening on the side of the can
shield should be opposite the seam on the can and the top and
bottom of the can shield should not overlap the lip of the can.
4. Apply a coating of light machine oil to the follower wiper (35)
before loading the gun with a can of sealant. This will lubricate the
seal and allow for easy entry into the can.
5. The spring loaded kick stand is “kicked” to one side to allow the
gun to be tilted backward and rolled.