0 assembly (continued) – Flowserve Cast Globe Valves User Manual
Page 32
Globe Valves FCD ADENIM0011-00
32
7.0
ASSEMBLY (continued)
7.2.3
Yoke
The same procedure detailed in 7.1.3 for flanged bonnet valves should be followed. However, with pressure
seal valves the yoke attachment interface is different. The following steps should be substituted accordingly.
With yoke in its proper position on the body neck, the halves of the yoke clamp (012) should easily fit over
the mating lips on the yoke and the body. The yoke clamp studs (204) can then be inserted, and the nuts
(233) threaded on and tightened.
7.3
Actuators
7.3.1
Manual
Reassembly of both gear actuators and handwheels can be accomplished by reversing the instructions
provided in sections 6.1.1.
7.3.2
Motor and Air Cylinder
Instructions pertaining to the assembly of specific power actuators are included in supplements to this
manual.
TYPICAL BOLT TIGHTENING SEQUENCE