Flowserve 3200IQ Digital Positioner Supplement - Manual (Page 5)

5 of 5
13.
Insert and attach the p lastic main PCB cover by
installing and tightening the two (2) short cover
screws, and one (1) long cover screw. Exercise
care to insure that the LED’s are properly aligned
so they aren’t bent or damaged by the cover as it
is being installed.
14.
Perform a Quick-CAL to recalibrate the piezo
assembly and the positioner. Refer to the
3200IQ IOM for detailed calibration and
configuration instructions.
(FCD LGAIM0058-00)
15.
Replace the driver module cover and main
housing cover.
MAIN
HOUSING
COVER
DRIVER
MODULE
COVER