Flowserve BK 15 - Manual (Page 9)

9
1. Take care of correct position of installation.
2. Take care of flow direction. The flow arrow is on the trap body.
3. Consider space required for opening trap. When the trap is installed a minimum
space of 90 mm is required for removing cover .
4. Remove plastic plugs. They are only used as transit protection.
5. Clean seating surfaces of both flanges.
6. Install steam trap.
Flanged Design
Installation
The steam trap BK 15 can be installed in any position. In the case of a horizontal
installation, make sure that the cover is at the top.
BK 15
Explanatory Notes
– continued –
Name Plate / Marking
Fig. 4
For further specifications according to EN 19 see trap body.
D
Regulator
Standard design
30 K undercooling U
Nominal size
Ratings acc. to
EN ISO 26552