Flowserve 025000 Series - Manual

1
Flow Control Division
Kammer Control Valves
11.00
Installation, Operation, Maintenance Instructions
Split Body Valves with Bellows Seal
Series 025 300 Globe Valves
Series 027 300 Angle Valves
Series 028 300 3-Way-Valves
1 GENERAL INFORMATION
These instructions are designed to support you when
unpacking, installing and per-forming maintenance
work on the valves. Users and maintenance person-
nel should carefully read these instructions before in-
stalling, operating or performing main-tenance work.
There is a separate set of instructions for accessories
(special seat/plug fittings, diaphragm actuators, hand-
wheels, special seats, etc.).
These instructions do not contain any information on
Kämmer positioners. For this, see corresponding in-
structions for the installation, maintenance, trouble-
shooting, adjustment and operation of Kämmer posi-
tioners.
To avoid damage or injury to personnel or equip-
ment, always heed all warnings and instructions.
Unprofessional re-conditioning, the use of foreign
replacement parts or the performance of other main-
tenance steps than those described here, may cause
a loss of efficiency or lead to personnel injury or
damage to parts, and render the warranty void
1.1 UNPACKING
1.1.1 Each delivery includes a packing slip. When unpack-
ing, check all delivered valves and accessories using
this packing slip.
1.1.2 Larger valves can be lifted using slings on the yoke
rods or, if present, on the lugs provided for this pur-
pose. If slings are used, attach them so that the outer
tubing or attaching parts are not damaged.
Important: If slings are used, be aware that the cen-
tre of gravity of the valve may be above the lifting
point. In this case, secure or support the valve
against rotating, to prevent damage or personnel
injury.
1.1.3 Report transport damage to the carrier immediately.
1.1.4 In case of discrepancies, contact your nearest dealer.
KMEIM2502-00 - 11.00