Commissioning procedure, Operation – Flowserve NRG16-41 User Manual
Page 23
Advertising
3
Apply power to switching controller NRS -4.
Commissioning Procedure
Make sure that the level electrode NRG ..-4 is properly connected to the switching controller
NRS -4 according to the wiring diagram,
Fig. 13.
Check wiring
Apply mains voltage
Operation
Used in combination with switching controller NRS -4 in (pressurized) hot-water plants and steam
boilers working in accordance with TRD 40, TRD 60, TRD 604 or other national regulations.
High-water level limiter (Max alarm)
Note
■
Should malfunctions occur during the commissioning procedure refer to section
“Troubleshooting” on page in order to find, analyse and eliminate the fault.
Advertising
This manual is related to the following products: