Drolet Nova 820 - Manual (Page 7)

ELATION Fireplace Insert 7
CAUTION: This insert is hot while in operation. Do not touch. Keep children, clothing and
flammable materials away.
WALL THERMOSTAT
To operate your ELATION using the wall thermostat, follow the lighting procedure and set the
gas control to the ON position. Simply set your wall thermostat to a comfortable temperature
and the insert will do the rest.
During the heating season, you do not have to touch the gas control valve. If you would like the
insert off for a while, just set the thermostat to its minimum setting. However if you do not
need the insert for quite some time, follow the procedure outlined in the SHUTDOWN section.
This will extinguish the pilot light as well.
SHUTDOWN
Push in and rotate the gas control knob clockwise to the "off" position. Do not force.
If you are going to perform any maintenance or cleaning, first allow the insert to cool
completely. Follow the instructions in the section on cleaning under MAINTENANCE
INSTRUCTIONS.
BLOWER
The blower control contains a variable speed switch and a thermal switch. When the insert is
operating, the thermal switch will turn on at 110° F, allowing the blower to operate . When the
insert cools to 90° F, the thermal switch turns off the blower in about 40 minutes. This prevents
the blower from operating when the insert is not in use.
The blower not only helps circulate air throughout the room, it also increases the heat output
and efficiency of the ELATION.