Flowserve 4 DK75 Position Output Module for DFP17 - Manual

4 DK75 Position Output
Module for DFP17
Installation, Operation and Maintenance
Figure 1 – 120/240 VAC Board shown
��
��
��
��
��
��
��
������������������������������
�����������������
����������������������������������
�������������������������������
�����������������
��
��
��
���
��
��
��� ��
���
���
���
���
���
���
���
���
��� ��
���
��
���
���
���
��
��
���
���
���
��
���
��
��
��
���
���
���
�
���
�
���
���
�
���
�
�� ��� ��� ���
���
���������
����������
��������
P1
TB2
3 4 2 1
BLUE
YELLO
W
ORANGE
1 Description
The 4 DK75 position output module is designed to be used with
and mounted on the Flowserve Worcester DataFIo Digital Positioner
(DFP17) Circuit Board in Series 75, 120/240 VAC or 24 VDC actua-
tors. Its output is suited for 4-20 mA DC meter with 0-100% scale
(such as General Electric Type GE185), which is not part of the pack-
age. If properly calibrated, it indicates actuator shaft position from
close (0°, 0%) to open (90°, 100%).
2 Installation
(See Figure 1.)
Parts included in kit:
Item Qty Description
1 3 Cable Ties
2 1 4-20 mA Module
3 1 Connector Assembly
The module plugs into the Digital Positioner Board in the area
marked “U6” for AC boards and “U4” for DC boards, and a con-
nector assembly connects the output at P1 to the actuator terminal
strip.
IMPORTANT: Looking at the top of the module, the pin that has
a square soldered area (adjacent to R3 on the module) has been
clipped off. This pin must be aligned with the filled socket marked
“GND” on the circuit board for proper installation. See Figure 1.
FCD WCAIM2064-00 (Part 19882)
Worcester Actuation Systems