Dolby Laboratories DP569 - Manual (Page 87)

Model DP569 User’s Manual
D–1
Appendix D
Error Messages
This appendix lists possible error messages that may be generated by the DP569. In
each case a description of possible setup conflicts are given that may have caused the
error. When a conflict occurs the parameter that caused the conflict will not be
updated but returned to its original value once the error message has been displayed.
NOT VALID: CHECK
DATA RATE
• A new Channel Mode has been selected but is not supported for the current
Data Rate.
• Internal 32 kHz has been selected as the Clock Source, the current Output
Mode is Pro 16-bit and the current Data Rate is 448 kbps or greater.
NOT VALID: CHECK
CHANNEL MODE
• A new Data Rate has been selected but is not supported for the current
Channel Mode setting.
• Main Srv Karaoke has been selected as the Bitstream Mode and the current
Channel Mode is 1+1 Dual Mono or 1/0 Mono; or Assc Voice Over has
been selected and the current Channel Mode is not 1/0 Mono.
• The LFE Channel has been Enabled and the current Channel Mode is 1+1
Dual Mono, 1/0 Mono, or 2/0 Stereo.
NOT VALID: CHECK
BITSTREAM MODE
• Either 1+1 Dual Mono or 1/0 Mono has been selected as the Channel Mode
and the current Bitstream Mode is Main Srv Karaoke. Or any selection
other than 1/0 Mono has been made and the current Bitstream Mode is Assc
Voice Over.
NOT VALID: CHECK
LFE MODE
• 1+1 Dual Mono, 1/0 Mono, or 2/0 Stereo has been selected as the Channel
Mode and the LFE Channel is Enabled.