Dolby Laboratories DP569 - Manual (Page 88)

Model DP569 User’s Manual Error Messages
D–2
NOT VALID: CHECK
INPUT FORMAT
• Ref In-SRC On or an Internal Clock Source has been selected and the
current Input Format is not PCM.
• Time Code Ctrl has been selected as the Encoder State and the current
Input Format is not PCM.
NOT VALID: CHECK
ENCODER STATE
• Time Code-based Recall has been selected and Encoder State is currently
set to Time Code Ctrl.
• Pre-encoded or Autodetect has been selected as the Input Format and the
current Encoder State is set to Time Code Ctrl.
• Multiplex Mode has been set to Enabled and the current Encoder State is
set to Time Code Ctrl.
NOT VALID: CHECK
MULTIPLEX MODE
• Digital Input or an Internal Clock Source has been selected, and Multiplex
Mode is currently Enabled.
• Pro 32-bit or Consumer has been selected as the Output Mode and
Multiplex Mode is currently Enabled.
• Time Code Ctrl has been selected as the Encoder State and Multiplex
Mode is set to Enabled.
NOT VALID: CHECK
CLOCK SOURCE
• Pre-encoded or Autodetect has been selected as the Input Format and the
current Clock Source is Ref In-SRC On or an Internal clock source.
• The Multiplex Mode has been Enabled and the current Clock Source is
Digital Input or Internal.
• A Coding Delay value less than 204 ms has been selected and the current
Clock Source is Internal 44.1 kHz, or a Coding Delay less than 280 ms has
been selected and the current Clock Source is Internal 32 kHz.