Dynex DX-19L200A12 - Manual (Page 14)

10
Making connections DX-19L200A12
Connecting an antenna or cable TV (no
box)
To connect an antenna or cable TV (no box):
1 Turn off your TV and all connected equipment.
2 Connect a coaxial cable (not provided) to the ANT.
IN jack on the back of your TV and to the antenna or
cable TV wall jack.
3 Turn on your TV, then go through the setup wizard
on page 15.
Connecting a DVD or Blu-ray player
Using HDMI (best)
To connect a DVD or Blu-ray player using HDMI:
1 Make sure that your TV’s power cord is unplugged
and the DVD or Blu-ray player is turned off.
2 Connect an HDMI cable (not provided) to the HDMI
IN jack on the back of your TV and to the HDMI OUT
jack on the DVD or Blu-ray player.
To play from a DVD or Blu-ray player using HDMI:
1 Turn on your TV, then press INPUT to open the
INPUT SELECT list.
2 Press or to select HDMI, then press ENTER.
3 Turn on the DVD or Blu-ray player, then set it to the
output mode. See the documentation that came
with the device for more information.
Notes
• Do not tie the coaxial cable together with the
power cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
Back of TV
Coaxial cable
Back of TV
DVD or Blu-ray player
HDMI cable
DX-19L200A12_11-0606 MAN_ENG_V1.book Page 10 Thursday, November 3, 2011 10:06 AM