Formax FD 2094 - Manual (Page 18)

13. The tear bar is adjustable to accommodate
characteristics of various forms. To adjust height, bar
must be pushed to compress spring and lift out. Rotate
180 degrees (turned over) and replace making sure that
square end of bar locks into brackets. (Fig. 26, shown in
HIGH position)
Fig. 25
Fig. 26
14
Burster Operating Hints
1. To stop the machine, push on either one of two stop
buttons. Opening safety cover or lifting jam detection
grill will also stop machine.
2. To restart machine start button must be pressed.
CAUTION: Machine will restart at same speed that it
was running at unless speed control thumbwheel is
turned down.
3. Some paper has a natural curve. Sometimes this
curve tends to catch air and sail. If this occurs, try
running them upside down.
4. Perforations vary in strength. If forms are bursting
hard, tearing, or breaking behind tear bar, vary form
length setting up to 1/2” ahead or behind actual form
size setting, and/or put tear bar in low position.