Formax FD 670 - Manual (Page 6)

2
FORM SPECIFICATIONS
Variable Speed 30-500 ft/mm (4.6-154 m/mm)
Capacity 1-8 pan forms
Maximum Depth 17 inches (43 cm)
Minimum depth 2 3/4 inches (7cm)
Maximum Width Before Slitting 19 1/4 inches (49cm)
Maximum Width After Slitting 17 inches (43cm)
Form Types Carbon or Carbonless
Form Weights 10 lb. to 140 Ib.
SPECIFICATIONS
Size-Model FD 676/680
Height 43”(109cm)
Width 31 “(79cm)
Length 56” to 68 1/4”
Actual 142cm to 173cm
Weight 330 lbs(149kg)
INSTALLATION
UNPACKING AND SET-UP
Do not destroy shipping cartons or materials until
machine has been inspected for damage, missing
parts, and proper operation.
1. Remove bands which hold cardboard box to
wooden pallet. Remove cardboard box.
2. Remove burster top supports.
3. Remove (4) carriage bolts: (2) on infeed end of
burster and (2) outfeed end. Hint: Leave carriage
bolts in place on center burster support,
4. Remove (4) foam blocks.
5. With allen wrench supplied, unfasten four
retaining bolts which hold machine to the board
immediately below it.
NOTE: Center burster support is not fastened to
burster.
6. Add burster feet to burster. (Fig. 1)
7. Remove burster table from its carton.
NOTE: Location of holes on top of table.
8. Set burster on table, lining up holes in table with
holes in burster frame. (Fig.2)
NOTE: Burster will line up evenly on all sides of the
table.
CAUTION: Lifting should not be attempted by
less
than four people.
9. Add 1/4-20 x 1 1/2 locating screws, (included),
to underside of table, screwing up into burster
frame.