Formax FD 130 - Manual (Page 11)

9
2. POSITIONING INK ROLL
The ink roll can be moved by opening the top cover and simply sliding
the ink roll assembly to the right or left as required (See Figure 10). The
ink roll must be positioned so that it inks the entire signature plate.
3. REPLACING INK ROLL
a. Open the top cover.
b. Put on the gloves shipped with the ink roll.
c. Pull the cotter pin out of the axle (see Figure 10).
d. Hold onto the ink roll and pull the axle out of the ink roll carriage.
e. Hold the new ink roll between the sides of the ink roll carriage and
insert the axle with the pointed end as shown in Figure 10.
f. Insert the straight side of the cotter pininto the hole in the pointed end
of the axle.
g. Push the cotter pin until the axle is secured between the two loops of
the cotter pin.
h. Close the top cover.
Axle
Ink Roll Cotter
Pin Top
Cover
Figure 10